A projector was shown in operation at the SID Conference 1972 in San Francisco. Wild working at Brown Boveri Research in Switzerland were conducted in 1971. The first experiments with a direct-driven, transmissive matrix-addressed LCD using a converted slide projector by Peter J. However, a similar concept was used for print heads without an LCD. ![]() No practical application of this concept for projection purposes is known. E-beam-addressing requires a CRT with a modified faceplate to generate a charge pattern on its surface. His concept was based on e-beam-addressing to generate an electronic charge pattern corresponding to a video image, which in turn controlled the LC layer of a reflective LC cell. van Raalte at the RCA-Laboratories in 1968. For example, if the throw ratio is 2:1 and the projector is fourteen feet away from the screen, then the display width will be seven feet.Įarly experiments with liquid crystals to generate a video image were done by John A. Color problems can sometimes be adjusted through the projector settings, but may not be as accurate as they would on a white background.Ī projector's throw ratio is used when installing projectors to control the size of the projected display. The trade-off is that darker backgrounds can throw off color tones. Because of this, some presenters and presentation-space planners prefer gray screens, which create higher-perceived contrast. However, darkest black in a projected image is dependent on how dark the screen is. Since white is more of a neutral color, white surfaces are best suited for natural color tones as such, white projection surfaces are more common in most business and school presentation environments. Perceived color in a projected image is a factor of both projection surface and projector quality. Even so, the best image quality is found using a blank white, grey, or black (which blocks reflected ambient light) surface, so dedicated projection screens are often used. ![]() ![]() Other technologies, such as Digital Light Processing (DLP) and liquid crystal on silicon (LCOS) are also becoming more popular in modestly priced video projection.īecause they use small lamps and the ability to project an image on any flat surface, LCD projectors tend to be smaller and more portable than some other types of projection systems. ![]() These lamps also have the ability to produce an extremely large amount of light within a small area current projectors average about 2,000 to 15,000 American National Standards Institute (ANSI) lumens. Metal-halide lamps are used because they output an ideal color temperature and a broad spectrum of color. The combination of open and closed pixels can produce a wide range of colors and shades in the projected image. As polarized light passes through the panels (combination of polarizer, LCD panel and analyzer), individual pixels can be opened to allow light to pass or closed to block the light. To display images, LCD ( liquid-crystal display) projectors typically send light from a metal-halide lamp through a prism or series of dichroic filters that separates light to three polysilicon panels – one each for the red, green and blue components of the video signal. It is a modern equivalent of the slide projector or overhead projector. An LCD projector is a type of video projector for displaying video, images or computer data on a screen or other flat surface.
0 Comments
Leave a Reply. |